Dowry for the kid: we sew

Accurate and clear drawing and sewing instructions: a cozy and warm, carefully folded envelope will inspire your child only good dreams.

• 
• 
• 
• 

For sewing this convenient (for parents too) little things you need only fabrics of pleasant colors, a warm pad (batting, non-woven), braid and buttons with buttons. Thanks to our precise measurements and a detailed description of the cutting and sewing, this envelope will be sewn even by mom, who, for the first time in her life, sat down at a sewing machine.
YOU WILL NEED

Cotton fabrics with 2 different patterns with a width of 110 cm: for the outer and inner sides of 0.80 m; volumenfliz non-woven P 140 (or 295) 0.80 m wide 150 cm; braid 0.60 m wide 2 cm; finished oblique cotton inlay 1.60 m wide 2 cm; 3 large buttons; 3 large buttons for sewing.
CUT
The outer and inner sides of the envelope are 80 cm long and 85 cm wide, including allowances. Under the part for the inside, notice volumeflis of the same size.
SEWING
■ Cut the tape into 2 equal parts. On the part for the inside of the envelope, stitch the pieces of braid along 80-cm sections at a distance of 1 cm, starting from the top section of the part. Tighten the lower end of the tape.
■ Fold the inner and outer parts of the envelope with the front sides; top sections cut at a length of 85 cm.Cut the volumetric allowances close to the line. Fold out internal and external parts, iron seam allowances. Fold each remaining slice 85 cm long in the middle with the front side inwards and chopped. Then put the chopped slices on top of one another and grind. Volumenfliz allowances to be cut close to the line. At the bend, cut the end of the allowances obliquely.
Pull the inner part of the envelope outward so that the inner and outer parts of the envelope lie on the wrong sides.
■ Sweep open and cut open sections of internal and external parts with an oblique in the following way: lay out one ironed section of an oblique inlet and sew it from the wrong side to the section at a distance of 1 cm (ironed bend). Unscrew the tape on allowances, tighten the ends of the tape. Unscrew the ribbon on the front side, rounding the slices, and stitching to the edge.
■ Lay out the envelope so that a sharp corner is formed below. Unscrew the side edges to the middle and lay one on the other 6 cm wide. For the fastener, sew 3 buttons at a distance of 3 cm from the front edge, 22 cm from the top edge. Sew buttons at intervals of 8 cm. Sew on the front side for finishing buttons (over buttons). Unscrew the top edge of the envelope, approx. 5 cm
Material prepared by Elena Karpova

Watch the video: DIY Room Decor ideaLove birdsEasy Woolen Bird craft. Wall Hanging Idea (December 2024).